Lincoln Food Processor 2806405 User Manual

opera tor ma nua l  
InstaSlic e™  
Series 15000  
This doc ument inc ludes:  
• Sa fety Notic es  
Opera ting Instruc tions  
• C lea ning Instruc tions  
• Wa rra nty Sta tement  
Revision: D  
P/N: 2806405  
Linc oln Foodservic e Produc ts, LLC  
1111 North Ha dley Roa d  
Fort Wa yne, India na 46804  
United Sta tes of Americ a  
Tec hnic a l Support Hotline: (800) 678-9511  
Telephone: (260) 459-8200  
www.linc olnsma llwa res.c om  
 
CAUTION:  
!
!
Blades are sharp and can cause injury. Check machine before using. Be sure machine is clean. Check for  
broken, nicked or dull blades and if found, replace blade assembly. Check to ensure that the pusher head sits  
down completely on the rubber bumpers. Lubricate if necessary using a light coating of mineral oil, Petrol Gel  
or food grade lubricant. DO NOT LUBRICATE WITH COOKING OIL AS IT WILL BECOME STICKY.  
PRIOR TO USING YOUR EQUIPMENT, IT IS IMPORTANT TO CLEAN THE UNIT.  
WASH NEW BLADES WITH WARM SOAPY WATER AND RINSE THOROUGHLY TO  
REMOVE THE THIN PROTECTIVE OIL FILM.  
CAUTION:  
!
OPERATING INSTRUCTIONS  
PLACE SLICER ON A TABLE OR COUNTER. POSITION THE INSTASLICE TABLE  
STOP OVER A TABLE EDGE TO HOLD THE MACHINE IN PLACE.  
CAUTION:  
!
1. Before each use, always check for proper blade tightness and unit cleanliness. Check for broken, nicked  
or dull blades and if found, replace blade assembly.  
2. This unit should be used to slice soft vegetables such as tomatoes, mushrooms, strawberries, etc. Hard  
foods such as onions, potatoes, lemons, etc. will cause blade breakage. Use a Tomato King Scooper to  
remove the stem scar of the tomato. For best results, the tomatoes should be clean and wet before slicing  
them in the machine.  
3. Spray the plastic platform and blades with water to reduce friction and repeat as needed during use.  
4. Place the tomato top down on the platform of the slicer against the pusher head. Place one hand on the  
pusher head handle and one hand on the knob on top of the slicer. With a quick push of the pusher head,  
push the tomato through the blades catching the slices into a pan placed at the end of the slicer.  
5. Repeat this process until you have prepared enough food for your daily needs.  
6. Rinse blades immediately. Failure to do so will shorten the life of the blades.  
CLEANING INSTRUCTIONS  
To insure optimal performance of the equipment, clean the machine after every use. Food acids corrode the  
cutting blades, ruining the cutting edges and reducing the cutting blade life.  
Refer to the illustration for additional assistance in reviewing the following cleaning instructions.  
BLADES ARE SHARP AND CAN CAUSE INJURY. NEVER USE MACHINE UNLESS  
ALL FOUR RUBBER FEET ARE IN PLACE.  
CAUTION:  
!
1. Place the pusher head in its most “OPEN” position by retracting the handle.  
2. Rinse or spray off the machine thoroughly with HOT water. You may want to immerse the complete  
machine in warm soapy water first.  
InstaSlice Operator Manual  
3
 
CLEANING INSTRUCTIONS (CONT’D)  
3. DO NOT WIPE BLADES OR USE SCRUB PADS IN THIS MACHINE. WIPING ACROSS THE SHARP  
EDGE OF BLADES CAN CAUSE INJURY AND WILL DULL THE BLADES.  
4. Do not put this machine in a dishwasher or dish machine with soaps, detergents, or other alkaline  
chemicals that can harm the machine.  
5. After cleaning, let the machine air dry.  
6. Lubricate sliding parts with mineral oil or Petro Gel after each use. Never use cooking oil as it will cause  
the machine to become sticky!  
BLADE / PUSHER HEAD MAINTENANCE  
1. Examine the pusher head fingers. If they are nicked or burred smooth the rough edges with a small flat file.  
The spaces between the fingers must be uniform. Straighten any bent fingers.  
2. Check the clearance between the pusher head fingers and the blades. Make sure they do not rest on or  
touch the blades at any point when you move the head through its full travel. If there is contact,  
adjustments must be made. PUSHER HEAD FINGERS MUST NEVER CONTACT BLADES.  
Adjust Pusher Head Finger spacing by placing a screwdriver between Pusher Head Fingers and gently  
rotate up/down. You may also adjust the entire Pusher Head Assembly by loosening the set screws  
underneath a rotating the guide rod as needed – tighten set screws.  
REPLACING BLADE ASSEMBLY  
1. Individual blades cannot be replaced. Replacement blades are available in assemblies only.  
2. Loosen the two thumbscrews on the top of the machine.  
3. Push the top of the blade assembly from the back towards the front and lift out. Replace in the opposite  
manner and tighten the two thumbscrews.  
4. Dispose of used blade assemblies properly.  
KEEP THE SHARP BLADE EDGES AWAY FROM HANDS WHEN HANDLING THE  
MACHINE.  
CAUTION:  
!
4
InstaSlice Operator Manual  
 
BLADE TROUBLESHOOTING  
IF THE MACHINE NO LONGER SLICES TOMATOES CLEANLY OR WITHOUT  
DAMAGE TO THE TOMATO, THE BLADES COULD BE DULL AND BE IN NEED OF  
REPLACEMENT. BROKEN, BENT OR NICKED BLADES MUST BE REPLACED  
IMMEDIATELY.  
CAUTION:  
!
SYMPTOM  
PROBABLE CAUSE  
Wrong food used in machine  
Fingers are misaligned  
Blades are dull  
EVALUATION  
Broken Blade  
Slice only what is recommended  
Readjust fingers  
Replace blade assembly as needed  
PREVENTIVE MAINTENANCE  
1. Clean machine after each use.  
2. Use for intended purpose.  
3. Change blades regularly – based on usage.  
InstaSlice Operator Manual  
5
 
SPARE PARTS  
LETTER  
PART NUMBER  
369211  
379063  
379064  
15112  
DESCRIPTION  
A
B
C
Thumb Screw  
Knob  
Bridge Casting  
Blade Assembly, 7/32” (scalloped blade)  
Blade Assembly, 1/4" (scalloped blade)  
Blade Assembly, 3/16” (scalloped blade)  
Blade Assembly, 3/8” (scalloped blade)  
Blade Assembly, 7/32” (straight blade)  
Blade Assembly, 1/4” (straight blade)  
Blade Assembly, 3/16” (straight blade)  
Blade Assembly, 3/8” (straight blade)  
Pusher Head Assembly Bolt  
Pusher Head Assembly (complete) 7/32”  
Pusher Head Assembly (complete) 1/4"  
Pusher Head Assembly (complete) 3/16” & 3/8”  
Shoulder Bolt  
15113  
15115  
15114  
D
15206  
15207  
15209  
15208  
E
F
379069  
379070  
379071  
379072  
379073  
379074  
379075  
379076  
379049  
379077  
353  
G
H
Handle Assembly  
I
Guide Rod (long)  
J
Table Stop  
K
Washer – Guide Rod  
L
Guide Rod (short)  
M
Nut – Guide Rod  
N
O
379078  
379079  
379065  
Rubber Foot  
Base  
Not Shown  
Guard  
6
InstaSlice Operator Manual  
 
EXPLODED VIEW DRAWING  
InstaSlice Operator Manual  
7
 
 

Krups Espresso Maker XP 1500 User Manual
Land Pride Lawn Mower 315 507P User Manual
Lanier Printer Accessories 5485 User Manual
LG Electronics Cell Phone AX5000 User Manual
LG Electronics MP3 Player PC12 User Manual
Lincoln Electric Welding System SVM173 A User Manual
Linksys Network Router WRVS4400N User Manual
Magnat Audio CD Player MC 1 User Manual
Master Bilt Refrigerator GT 50 User Manual
Mercedes Benz Automobile 2004 C Class Wagon User Manual